High Mast Pole

We are engaged in manufacturing and supplying the premium quality of HIGH MAST  POLES & Lights. Recognized for their durability, Heights and Designs, alluring appearance and resistance against harsh weathering conditions

Material used are based on the following standards Octagonal Poles : HT Steel Conforming to grade S355JO or equivalent Base Plate : Fe 410 conforming to IS 226/IS 2062 Foundation Bolts : E.N.B. grade Design : The Octagonal Poles are designed to withstand maximum wind speed as specified in IS875. The top loading area and the weight of fixtures are considered while calculating the maximum deflection of the pole and to meet the requirement of BS : 5649 Part VI 1982. Pole Shaft : The Pole shafts have octagonal cross section and are continuously tapered with single longitudinal welding. There are no circumferential welding. They are provided with rigid flange plate of suitable thickness with provision for fixing 4 foundation bolts. This base plate is fillet welded to the pole shaft from inside and outside. The welding is done by MMAW process. Door opening : The octagonal poles have a door of approximate 500 mm length at the elevation of 500 mm from the Base plate. The door is vandal resistant and weather proof to ensure safety of internal connections. The door is flush with the exterior surface and has suitable locking arrangement. There is also a suitable arrangement for earthling. The poles are adequately strengthened at the location of the door. Welding : Welding is carried out confirming to approved procedures duly qualified by third party inspection agency. The welders are qualified for welding octagonal shafts. Pole Section : The Octagonal Poles are in single section (up to 9 meters) without any circumferential weld joint. Galvanizing The poles are hot dip galvanized as per IS 2629 / IS 2633 / IS 4759 standards with average coating thickness of 70 micron. The galvanizing is done by single dipping Fixing Type : The poles are hot dip galvanized as per IS 2629 / IS 2633 / IS 4759 standards with average coating thickness of 70 micron. The galvanizing is done by single dipping.

Mast Structure Construction The mast is provided with a fully penetrated flange, which is free from any laminations or incursions. The welded connection of the base flange is fully developed to the strength of the entire section. The base flange is provided with supplementary gussets between bolt holes to ensure elimination of helical stress conectration. For environmental protection of the mast, the entire fabricated mast is Hot dip Galvanized (Single Dip) internally and externally, that results in uniform coating thickness of 65 to 85 as per sheet thickness & maintaining BSEN ISO 1461 or equivalent.

Mast Structure Construction The mast is provided with a fully penetrated flange, which is free from any laminations or incursions. The welded connection of the base flange is fully developed to the strength of the entire section. The base flange is provided with supplementary gussets between bolt holes to ensure elimination of helical stress conectration. For environmental protection of the mast, the entire fabricated mast is Hot dip Galvanized (Single Dip) internally and externally, that results in uniform coating thickness of 65 to 85 as per sheet thickness & maintaining BSEN ISO 1461 or equivalent.